✨48% OFF✨Solution Welding Flux-Cored Rods

Welding Instructions:

1. Through physical cleaning, polishing the surface, cleaning the grease on the surface of the weld, and using a steel brush or copper brush to remove the plating layer, etch, paint, oil, oxide and other coatings.
2. Heat the surface of the base metal at the welding place (do not directly burn the electrode) until the temperature reaches 550 degrees, the working temperature of the welding wire. When the surface temperature of the base metal is sufficient, the welding wire can flow and penetrate to the Jinzhan capillary well.
3. When repairing thin aluminum parts, just heat the aluminum base material to a suitable working temperature, and then use the welding wire to friction and fuse to form a weld. Only the gold high brush melted welding wire is used to fill the weld to form a weld.

Caution:

• The surface of the base material must be cleaned and dried, that is, clean and welded. (Cleaning up the surface of the base material refers to the removal of electroplating, corrosion, paint, oil, oxide, etc.)
• The temperature of the base metal must reach 550°C, including the temperature of the base metal during the welding process, should be kept at about 550°C.
• Never apply heat directly to the rod as it will crumb, and if you manage to melt the rod directly, the weld will be easily breakable. Remember, melting the rod directly is a wrong way, and makes crumby welds.

Just a few of the many parts that can be easily repaired!