TailBeam Pro LED Light
TailBeam Pro LED Light
Quad Row Lighting
Built To Last
– When signaling, the light will blink yellow simultaneously with your blinker
– When breaking, the light emits 100% red light
– When in reverse, the light will release a bright white color
Q: Will The TailBeam Pro Fit My Truck?
A: To figure out if the TailBeam Pro will fit your truck, simply measure the width of your tailgate in inches. The TailBeam Pro will fit most trucks with an overall length of 60 inches.
Q: How Many LEDs Are In The TailBeam Pro?
A: There are 432 LED’s spread out across the 60” light!
Q: What Are The Dimensions Of The TailBeam Pro?
A: The light is 60” in length by 2” in height and .5” deep (60” x 2” x 0.5”)
Q: How Much Power Is In The TailBeam Pro?
A: Wattage is 1w, Voltage is 12v & Amperage is .25amp.
Q: How Many Hours Will The LEDs Last?
A: Rated lifetime use of 50,000+ hours!
Q: Is It Protected During The Rain Or Snow?
A: Yes, it is 100% waterproof with a IP68 rating, we will ensure it can withstand almost any environment.
How To Install To Your Truck
Step 1: Testing & Connecting
Trucks Equipped With A 4-Pin Trailer Tow Plug: Directly plug in the 4-pin adapter and test the running, brake, and turn signal lights on. Then proceed to step two.
Trucks That Do Not Have A 4-Pin Trailer Tow Plug: Identify which wire is running, brake, turn signal, or reverse wire from the exiting trailer tow wiring. If you can’t make sure the wires, then test with a multi-meter by turning on the light orderly. The wire with voltage output is the corresponding signal wire.
Step 2: Wire The Reverse Light
Remove and unplug one of your tailights. Identify the reverse wire by activating the trucks reverse light and test each wire with a voltmeter to see which on output an 11-12V. Once you’ve found the wire, splice it with the external red wire of the TailBeam Pro.
Step 3: Mounting
(Before mounting please make sure your turn signals are in a proper direction, because it may be in the opposite place depending on how you mounted the TailBeam Pro.)
Unhinge and remove your vehicles tailgate. Clean surface thoroughly and make sure no dirt or dust is present, as it will reduce the strength of the adhesive tape. Prime the are with the adhesive tape brackets provided in your kit. Peel off the protective foil from the back of the TailBeam Pro. Apply the TailBeam Pro left to right and press it firmly on the tailgate for 30 seconds for every 12 LEDS. Finally, test the tailgate light again to make sure no wires are loose during installation, and that all lights are properly lighting/reacting.